MS Readiness Assessment
Overview This article describes the Exinda's functionality of Monitoring and Reporting IP Addresses or hops between the source and destination IP Addresses. Information Exinda does not perform Monit...
OverviewWhen looking at the Monitor > Control in the information table, the 'Max Rate' is mentioned. This number may appear to be higher than anything appearing on the graph above this table. This is ...
Overview The default settings for the number of chart and tables items are as follows: Object Number of Items Chart 08 Table 30 Table 1.0 The values shown in Table 1.0 implies that a Chart (e.g., Pie ...
OverviewThe manufacturer of the Exinda 4010 units reports the following fiber SFPs as compatible: Brand Vendor P/N SPEED Type Type Eoptolink EOLS-8512-02 1Gb Multi mode SFP FINISAR FTLF1318P2BCL 1Gb S...
Overview When a particular Exinda is optimizing traffic of multiple WAN locations, sometimes the data in the Graph of Virtual Circuit 1 (VC-1) might show up in the Graph of VC-2. All the data which is...
OverviewUser needs to control Microsoft One Drive and there is no signature for that application CauseMicrosoft One Drive is instead being classified as Live.com and Skydrive. See picture below: Resol...
OverviewMemory on the 4010 cannot be upgraded. This option can only be explored on virtual appliances, or on appliances using Dell server hardware....
OverviewThere is a known issue with memory paging alerts which come up in earlier versions of ExOS 7. If the appliance is using version 7.0.0, 7.0.1 or 7.0.2, it is recommended to upgrade to at least ...
OverviewThe maximum number of policies is a variable that is part of the Exinda license based on the Exinda hardware. To see this value for your specific device, go to: Configuration-->System-->Setup-...
Overview With Application Signatures, there can be updates or additions created in all Firmware updates. New Services, Protocols, Improvements of detection, etc., can happen in any release of the Firm...
