Articles

Issues and Manuals related to Hardware appliances

• Viewing/Setting up iDRAC IP on Exinda Dell Server

  Overview Dell's Integrated Remote Access Controller (iDRAC) gives remote access to the Dell server the Exinda is running on. It shows things like server health, power options, etc. This article gives ...

• Error Message: "Serial main process terminated" and Respawns Repeatedly

  Overview This article provides steps to resolve the serial main process terminated error found in the log file. The serial main process terminates and respawns repeatedly. When checking the interfaces...

• How to determine if the power supply is faulty

  SummaryA faulty power supply will present in multiple ways depending on model. Overview A faulty power supply will present differently depending on model. If the appliance only has a single power supp...

• Remanufacturing Exinda appliance

  Overview When all the system NICs appear in Down or Unknown status, the Exinda installation may become corrupted. If there are no bridges' LED indicators and the appliance was rebooted multiple times,...

• Bridge NIC Status Lights

  Overview This article provides status information on the Bridge NIC lights. Information There are some LED lights on the NIC cards, which indicates the following status: LED Lights Status Left LED fla...

• Error 'No boot device available' Powering-Up Exinda Appliance

  Overview The Exinda appliance is dependent on its hard drive in order to load the firmware of the device. In certain devices, after a power failure, Hardware failure or a drive going bad (riddled with...

• WAN and LAN interfaces are not working

  Overview Your Exinda device is experiencing problems with its LAN and WAN interfaces. They do not turn on their respective ports and the web interface is inaccessible. Looking at the device itself, th...

• 'No boot device available' error message on Exinda 8064

  Overview Your Exinda 8064 system fails to start properly at boot and there is a boot BIOS error message: PXE-E61 Media test failure, check cable. No boot device available. RAID-1 is found to be config...

• Hard Drive Amber LED Light on an Exinda 8063 with RAID Configuration

  Overview This article details when you have a possible hard drive failure on an Exinda 8063 with RAID configuration. You notice a red or amber light on one of the hard drives.  Solution Remove the har...

• Exinda stuck at System Initialization (code 42) screen while booting

  Overview While booting up, your Exinda device does not go past the initial boot sequence, and stops at this System initializing screen, with code 42 displayed: Solution Please try to perform a hard re...