Overview

To use the Virtual Router Redundancy Protocol (VRRP) with Policy-Based Routing (PBR) and VLANs (Virtual Local Area Networks), you should specify the behavior of the switch interfaces connecting to the router and the out-of-path Exinda appliances.

This article provides step-by-step instructions on how to configure a switch for VRRP with PBR and VLANs.

Process

1. Launch the CLI for the switch.

• To enter the privileged EXEC (enable) mode, run the following command:
  
  

  hostname > enable

• The hostname # prompt appears.
  
  
• To enter the configuration (config) mode, run the following command:
  
  

  hostname # configure terminal

• The hostname (config)# prompt appears.

interface GigabitEthernet0/1

switchport trunk encapsulation dot1q

switchport mode trunk

interface GigabitEthernet0/2

switchport trunk encapsulation dot1q

switchport mode trunk

interface GigabitEthernet0/3

switchport trunk encapsulation dot1q

switchport mode trunk

interface Vlan10
no ip address
interface Vlan20
no ip address

Related Articles

• Configuring a Router for VRRP With PBR and VLANs
• Configuring an Exinda Appliance for VRRP With PBR and VLANs Using Exinda Web UI
• Configuring an Exinda Appliance for VRRP With PBR and VLANs Using CLI