Overview

This article provides information regarding the Exinda CLI command acceleration mapi.

You can use the acceleration mapi command to accelerate e-mail traffic being sent to and from a Microsoft Exchange server.

Information

NOTE: The following syntax convention is used:

{}: Options are enclosed in braces and are separated by '|'
[]: Optional keywords are enclosed in brackets
<>: User input is required where variables are enclosed in greater-than and less-than symbols

The following table describes the commands used for configuring MAPI acceleration and viewing MAPI acceleration configuration and status:

Action Description	Command	Parameter Description
To enable or disable MAPI (Messaging Application Programming Interface) acceleration	`[no] acceleration mapi enable`	Not Applicable
To accelerate or disable acceleration of MAPI traffic using only basic header marking	`[no] acceleration mapi basic-header-marking-only`	With basic header marking, only the top-level RPC (Remote Procedure Call) header of each message is ignored when the traffic is accelerated. When basic header marking is enabled, performance is good, but there is less reduction in MAPI traffic. When basic header marking is disabled, performance is slower but provides better reduction by decoding lower levels of the protocol. The default setting is disabled.
To display MAPI acceleration configuration	`show acceleration mapi config`	Not Applicable
To display the state of MAPI acceleration	`show acceleration mapi`	Not Applicable