Overview
This article provides information regarding the Exinda CLI command vlan vlan-id.
You can use the vlan vlan-id command to create a VLAN interface. VLAN interfaces are typically used in a trunk Topology to associate a VLAN ID to the interface that is used to manage the appliance.
Information
- {}: Options are enclosed in braces and are separated by '|'
- []: Optional keywords are enclosed in brackets
- <>: User input is required where variables are enclosed in greater-than and less-than symbols
The following table describes the commands used for configuring and viewing VLANs:
| Action Description | Command |
Parameter Description |
|
To associate a VLAN ID with an interface |
vlan vlan-id <id> interface <inf> |
Not Applicable |
| To create a VLAN object, which can be used in the Optimizer |
|
Set the ID range. To match a single ID use the same number for low and high. |
|
|
Set the priority range. To match a single priority, specify the same number for both low and high. |
|
| To remove a VLAN object |
|
Not Applicable |
|
To show VLAN objects |
show vlan object <vlan> |
Not Applicable |
Example
-
Create a VLAN Object that defines all tagged VLANs with a VLAN ID between 2 and 7 (inclusive).
vlan object VLAN1 id 2 7
-
Create a VLAN Object that defines all tagged VLANs with a VLAN priority of 2.
vlan object VLAN2 priority 2 2
-
Show VLAN object info
show vlan object VLAN1
Output:
Object: VLAN1
ID, Lower limit: 2
ID, Higher limit: 7
Priority, Lower Limit: 0
Priority, Higher Limit: 7
Type: 802.1Q
Find more CLI commands.