Overview
To use the Virtual Router Redundancy Protocol (VRRP) with Policy-Based Routing (PBR) and IP Service Level Agreement (SLA) tracking, you should configure the interfaces on the Exinda appliance, using the Exinda web UI or the Command-Line Interface (CLI).
This article provides step-by-step instructions on how to configure an Exinda appliance for VRRP with PBR and IP SLA tracking using the CLI.
CAUTION! Configure your appliance using the IP addresses that correspond to your network. The IP addresses and netmasks used in this article are for demonstration purposes only.
Process
- On the out-of-path Exinda Appliance # 1, launch the Exinda web UI.
- In the browser address field, type
https://<Exinda_IP_address>
. - Enter the username and password for the appliance.
- Click Login to display the Exinda web UI.
- Ensure you are in Advanced mode.
- Go to Configuration > System > Tools > Console.
- Type the appliance username and password at the prompts.
- To enter the privileged EXEC (enable) mode, run the following command:
hostname > enable
- The hostname # prompt appears.
- To enter the configuration (config) mode, run the following command:
hostname # configure terminal
- The hostname (config)# prompt appears.
hostname (config)# no bridge BR10 enable
hostname (config)# interface eth11 ip address 10.10.10.2 /8
hostname (config)# pbr interface eth11
hostname (config)# pbr interface ip next-hop 10.10.10.1
hostname (config)# no interface eth11 dhcp hostname (config)# interface eth11 display hostname (config)# interface eth11 duplex auto hostname (config)# interface eth11 mtu 1500 hostname (config)# no interface eth11 shutdown hostname (config)# interface eth11 speed auto
hostname (config)# vrrp interface eth11 delay 1> hostname (config)# vrrp interface eth11 enable hostname (config)# vrrp interface eth11 priority 100 hostname (config)# vrrp interface eth11 vip 10.10.10.100 hostname (config)# vrrp interface eth11 vrid 50