Phone Lines icon GFI Support Home

Articles in this section

See more

Exinda CLI: Active Directory

Author: Sughra Mehdi Updated

Overview

 

This article provides information regarding the Exinda CLI Command active.

You can use the active command to configure Active Directory (AD) settings on the appliance. Note that more steps may need to be taken outside the appliance to install and configure the Exinda AD Connector.

 

Information

 

NOTE:  The following syntax convention is used:
  • {}: Options are enclosed in braces and are separated by '|'.
  • []: Optional keywords are enclosed in brackets.
  • <>: User input is required where variables are enclosed in greater-than and less-than symbols

The following table describes the commands used for performing common actions related to Active Directory:

 

Action Description 

 Command Parameter Description

To set the listen port for the Active Directory daemon

 active port <port number> NA (Not Applicable) 
To force the Active Directory service to re-send information active renumerate {all|logins|users}
  • renumerate all - Re-fetch the entire list of users and logins.
  • renumerate logins - Re-fetch the entire list of logins from all clients.
  • renumerate users - Re-fetch the entire list of users from all clients.
To manage the Active Directory services, such as starting, stopping, restarting service add {stop|start|restart|enable|disable}
  • add start - Start the service
  • add stop - Stop the service
  • add restart - Restart the service
  • add enable - Enable the service
  • add disable - Disable the service

To show the current Active Directory service details

 show service add NA (Not Applicable)

 

Find more CLI commands.

Back to Top

Related articles