The following commands are used to configure CLI options:
-
To save the running configuration, type:
configuration write
-
For the administrator to set the terminal character width and number of lines if required are as follows:
-
cli session terminal width <number of characters>
-
cli session terminal length <number of lines>
-
-
Auto logout is enabled by default, to change the auto-logout time use the following command:
cli default auto-logout <minutes>
To disable auto-logout, set the minutes to 0.
-
To enable or disable paging, use the following command:
[no] cli default paging enable
-
Use the below command to see the current CLI settings:
show cli
A sample output of the above command is as follows:
CLI current session settings:
Maximum line size: 5600000
Terminal width: 79 columns
Terminal length: 26 rows
Terminal type: xterm
X display setting: (none)
Auto-logout: 15 minutes
Paging: enabled
Progress tracking: enabled
Prefix modes: disabled
CLI defaults for future sessions:
Auto-logout: 15 minutes
Paging: enabled
Progress tracking: enabled
Prefix modes: disabled
Settings for both this session and future ones:
Show hidden config: yes
Confirm losing changes: yes
Confirm reboot/shutdown: no
Confirm factory reset: yes
Prompt on empty password: yes
Exinda-3062NH (config) #